Call: 800-537-0463 Mon - Fri: 8:30 am - 5 pm CST
0 item(s)

Banner Hanging Style Options

Banners can be used indoors or out. How the banners will be used, (displayed), normally prescribes how the banner is finished. When displaying banners outside always think safety first. Be sure the supporting structure is sound, banners hung out in the open can be subject to significant wind loads. Be sure you have enough tie points and strong enough banner construction.

Request a quote with your banner style choice by filling out our form and mention the specific style in the feedback area.

Style A

Hem edges with grommets top and bottom as needed, (number of grommets depends on banner size). Gold, silver and black grommets are available.
Most common finishing, useful for a variety of applications. Best for mounting against a wall or fence.

Grommet Banner Display Style A

Style B

Hem edges with grommets top and bottom as needed, with rope sewn into the top and bottom hems, rope ends extend out from the banner edge making ties, length can be specified. This adds versatility and strength to the basic grommet style, allowing the banner to be tied between poles or other secure fixtures.

Grommet Rope Banner Display Style B

Style C

Hem edges with rope sewn into the top and bottom hems. Rope extends from banner making ties, length can be specified. For banners tied between secure fixtures, this is a strong construction, it spreads wind forces over the length of the banner.

Rope Banner Display Style C

Style D

Hem sides with webbing sewn into top and bottom, webbing extends as needed for ties. This is an even stronger construction for banners that may be subjected to higher wind loads.

Web Ties Banner Display Style D

Style E

Hems sides, webbing top and bottom with grommets spaced as needed (depends on banner size). Adding grommets offers more tie down points, this is especially helpful to support larger banners to eliminate sagging, if the supporting structure will allow for it.

Grommet Web Ties Banner Display Style E

Style F

To support banners on hardware, sleeves can be sewn into the top and bottom, The sleeve can be sized to fit the hardware, The circumference (dia. X 3.14) of the supporting pole, divided by 2 plus an inch will calculate a good sleeve size.

Sleeve Banner Display Style F

Style G

Grommets can be added to the top and bottom in an extra extension above and below the sleeves for more versatility in display options.

Sleeve and Grommet Banner Display Style G

Style H

Street, or light pole banners are usually finished with sleeves top and bottom with a grommet just below the top sleeve and just above the bottom sleeve.

Sleeve and Grommet Banner Display Style G

Style I

For a very strong construction which will be attached using ties you supply, sewn in webbing with "D" rings offers a very reliable solution. For large banners, needing more tie points, grommets can be added to the top and bottom, or even sides.

DRing Banner Display Style I